Mielke's
Fiber Arts, LLC
Your Central Wisconsin source for weaving,
spinning, knitting, crocheting, tatting, bobbin lace, felting, dyeing, and
locker hooking equipment, books, and supplies.
|
|
|
Home
PRODUCTS
|
Schacht Small Looms [inkle] [rigid
heddle] [school loom] [mini loom] [table] [tapestry]
Schacht Inkle Loom Inkle looms are great for
start-up weaving programs because they require little additional equipment, are
easy to use and understand, and are easily stored. The Schacht Inkle loom is
built with years of heavy use in mind. It has one open side for ease
of warping. The tension bar has an easy grip handle for adjusting the warp
tension during weaving.
Schacht
Inkle Loom Manual (PDF) Schacht's belt shuttle has one
beveled edge which is great for both holding yarn and for beating the
weft...$10.00
Cricket Loom NEW!! The Cricket Loom is compact, capable and cute! At only 11" x 18" x 6" and just under four pounds, it's easy to take along. The ten inch weaving width gives plenty of room to make a variety of projects without sacrificing portability. Comes with two stick shuttles, a warping peg, threading hook, two table clamps, and 8-dent rigid heddle reed,
two balls of yarn, and instructions for weaving your first project! Read
a review of the Cricket Loom at Knitty.com
Cricket
Assembly and Weaving Manual (PDF)
Accessories
Flip the Folding Loom Weave in comfort. Choose three different weaving modes: use the
rear leg for hooking to a table edge, clamp it to a table for stand-up weaving,
or install it on our convenient trestle stand. Warp in a flash. Included with Flip, the folding loom, are
clamps and a warping peg for direct-loom warping. We include instructions for
both direct and pre-measuring methods. The top cross brace allows long warps, up to 5-6 yards
(depending on weight and winding paper), to be wound on the beams without
impacting the size of the shed. Fine-toothed
nylon ratchets provide precise tension control. The conveniently located heddle
blocks on the sides of the loom hold the rigid heddle in the up, down, or
neutral position. The heddle, available in 8, 10 and 12 dents per inch, is made
of durable ABS plastic, with large eyes and slots. Flip is available in 15”, 20”, and 25” weaving widths, and
includes an 8-, 10-, or 12-dent reed, warping peg, 2 shuttles, threading hook,
and complete warping and weaving instructions. Flip The Folding Loom
Schacht Rigid Heddle Reeds
Schacht School Loom What's most important in a loom for young
weavers is that it ensures success. Schacht has designed this simple
frame loom to do just that. It has a 15" weaving width, a built-in
stand for upright use on the floor or a table top, plus durable, 6 per inch,
plastic warp spacers for uniform warping. Students of all ages will find
it easy to use. Included with each loom are two pick-up sticks, a weaving
needle, and simple warping and weaving instructions. The School Loom is
made of hard maple and left unfinished.
Replacement Parts for the School Loom
Mini Loom Weaving Kit Schacht Table Looms (for Schacht table loom stands, see below) Table looms are great for classroom use,
workshops, sampling, and small projects. They are ideal for learning about
four- and eight-shaft pattern weaving, since the direct tie-up through the hand
levers allows for infinite experimentation. Schacht table looms are available in three
weaving widths -15", 20", and 25"- with four or eight shafts.
The looms come with a carbon steel reed in your choice of 6, 8, 10, 12, or 15
dents. Flat steel heddles, two apron rods, and three lease sticks are also
included. A double back beam is available for all 8 shaft table loom widths
(see
below). 4 Shaft Table Looms 8 Shaft Table Looms Schacht Table Loom Stand Schacht's X-frame floor stand makes the table
loom the correct height to be used with a standard chair. Installation is
simple - just fit the holes in the base of the loom onto pins in the stand.
The floor stand will fit older model table looms by drilling holes in the bottom
of the table loom using the drill guide provided. Schacht Table Loom Double Back Beam Kits Schacht Tapestry Loom Tapestry weaving is considered
by many to be the most personal of all weaving. Among the simplest of
looms, the tapestry loom holds a continuous warp under tension, allowing the
weaver to see all of the warp at once. Sheds are formed using heddle bars
and string heddles. While only two heddle bars are needed for traditional
tapestry weaving, we provide four heddle bars so that beginning weavers can also
experiment with 4-shaft pattern weaving. To keep the warp tension even
throughout your weaving, the tapestry loom has a tension beam with thumbscrews
on the end which allow for easy adjustment. Available in 18" and
25" weaving widths, Schacht's continuous warping system allows a 60"
long warp to be put directly on the loom without using any other warping tools. Portable Tapestry Loom Stands "A" Frame Stand
[inkle] [rigid
heddle] [school loom] [table] [tapestry] URL for this page: http://www.mielkesfiberarts.com/sch_sm_lms.htm
| |||||||||||||||||||||||||||||||||
|
[Home] [Useful
Information] [Site
Map] [What's New] [Order] [Shipping]
[Classes]
[Contact Us] prices subject to change without notice, due to manufacturer's
price changes Mielke's Fiber Arts, LLC 3086 County Road PP
Rudolph, WI 54475-9406
|
Flip is ideal for plain weaves and pick-up patterns. Our
exclusively-designed two heddle capabilities make sense of 2-heddle weaving for
the first time.
